How to Install TPO Roofing – A Few Things to Keep in Mind
How to Install TPO roofing depends on whether you’re doing it yourself or having it installed by a professional. If you’re doing it yourself, you’ll need to follow these steps to properly install your own TPO roof. Otherwise, you could end up with damage to your home and damage to your credit. Keep in mind that there are many different ways to install TPO roofing and the right way depends on your particular circumstances. The easiest way to install it, for the most part, is to have a professional do it.
The easiest way to install the roofing is to use aluminum flashing along the rafter edges and to install the shingles per m2. Aluminum flashing is usually used to “ties up” the per m2 at the edge of the roof and also to act as a barrier against rain water run off. It’s important to have enough of this flashing to effectively cover the entire rafter edge. The amount of per m2 will depend on the manufacturer of your roof slates.
If you have a “box gutter” style roof, then you won’t need to have any extra to roofing. All you need to have is an adequate layer of flashing around the perimeter of the box gutter. If you have a gambrel style roof, then you will need additional tarring and extra tar paper. The gutter sections will require some overlap at the bottom of each section so that water can drain away from the house. You can buy prefabricated the roofing panels that will fit over the existing roof, so you don’t need to cut into the existing roof.
How to install the roofing systems will differ slightly if you have a flat roof or a pitched roof. If the flat roof, you can install the shingle using standard hardware, or you can buy specialty tpo roofing material. Make sure that all nails are galvanized and the nails are long enough to keep the shingle in place when it rains. This makes sure that your tpo roofing system will work in a wet climate.
The pitched roof has a special solution for how to install the roofing systems. When you pitch the roof, the asphalt has an edge to it, which will allow it to lay tightly on the slates. Make sure you have enough tar paper or other roofing material on hand to adequately cover the entire roof and that the nails are long enough to keep the tar paper in place.
One more thing you want to make sure you have on hand before you install any roofing system is an escape route. All roofs have different methods of escape and it’s important to know how to escape safely in the event of a ceiling falling. It’s also important to make sure any skylights or other openings are sealed properly. Also, any open skylights need to be covered so they don’t become a possible way for water to get into your house. If you do those things before you install your roof, you won’t have any problem at all.