Learn How to Install Metal Roofing on a Shed

how to install metal roofing on a shed

Learn How to Install Metal Roofing on a Shed

How to install metal roofing on a shed is easier when you have a shed plan. If you do not have a plan, then you are at a disadvantage. Not having a plan will make learning how to install metal roofing on a shed a disaster. There is just so much to learn.

First off, you will probably need to clear any old roofing or shingles of your shed. Be sure to get rid of any nails or anything else sticking out at the top of the roof. The easiest way to do this is with a power washer. You will also want to sweep up any debris such as leaves or grass clippings. Insulating the top by putting building paper between the shingles, placing a layer of building paper on top of the roof, and using insulation tape to hold everything in place can all be done in that last step before you start installing the metal roofing.

Next, it is time to measure the shed roof. Get an accurate measurement to make sure you get a good fit. To find out what the correct measurement is for your particular shed roof, take a tape measure from top to bottom, across the grain, and two sides to side. This will give you a nice easy to read scale to help you when learning how to install metal roofing on a shed roof.

When learning how to install metal roof on a shed, one important thing to remember is to have a plan ahead of time. If you do not have a blueprint, find a local home improvement store that sells pre-fabricated metal roof plans. These plans are easy to read, detailed, and usually include a cutting list. Once you have your cutting list, make two or three copies, and then bring them with you to your local home improvement store. Most stores have a metal roof installation specialist that will install the metal roof for you. It is a good idea to take a few moments and review these plans before beginning.

After learning how to install metal roofing on a shed, you will need to learn how to anchor each piece securely to the other pieces. Metal is a lot less resistant to weather damage than shingle roofing, so you should consider purchasing a protective weatherproof coating for each piece. For example, if your metal roof has flashing, the flashing should also have this type of coating applied to prevent rainwater or snow from seeping into the roofing materials. This will allow you to protect your investment over the long haul.

Once you have your metal roofing installed, you can install the underlayment. Most often, the underlayment will be installed right over the top of the metal roof. The reason for doing this is to protect the sub-floor underneath the shed from moisture. Over time, if the area becomes wet, water will seep underneath the shed as well. An underlayment can help prevent moisture from forming under the floor, which will allow you to avoid mold and other unsightly problems.

This entry was posted in General. Bookmark the permalink.