How to Overlap Corrugated Metal Roofing

Metal roofing has been around for a long time. It is a very stable building material with an extensive history of use. The metal can withstand extreme weather and climates, as well as providing excellent insulation against fire. In fact, the metal roofing can also be installed in less favorable conditions such as coastal areas. The only problem that many people have with this type of roofing is how to overlap it without creating leaks.

how to overlap corrugated metal roofing

There are several ways of overlapping corrugated metal roofing. One of the most common ways is through the use of “hot roll” machines or hot rollers. These devices are able to apply even pressure on the metal to overlap it, thereby producing an overlapping pattern on the corrugated metal. However, this method is not applicable to all situations.

Hot rollers can cause damage to the corrugated metal. This may lead to an early, premature failure of the corrugated metal roofing. Another common method of how to overlap corrugated metal roofing is through the use of an electric trowel. The trowel is able to penetrate the coating of the corrugated metal. This method is useful for smaller roof sections. However, for roofs larger than five square feet, an electric roller or sprayer is the most appropriate.

The metal roofing can also be overlapped using a hammer. However, it is not advisable to do this procedure unless one has sufficient experience and skill. If the metal roofing is made of sheet metal, it may be difficult to make it overlapped using a hammer as the metal could be bent. It is also possible that the hammer may produce damage to the corrugated metal. If you are uncertain about how to perform this procedure, you may contact the manufacturer of the metal roofing to get assistance.

You can use a sheet metal shapes to help you do the process of how to overlap corrugated metal roofing. You should first apply the corrugated metal shaper over the corrugated metal roof in order to create a slot. You should then carefully align the corrugated metal so that the slot is directly over the overlapping portion. If you have any doubt about how to do this, you may contact the manufacturer of the metal roofing.

When the corrugated metal has been properly aligned, you should slowly and gently slide the metal shaper out until the slot is directly opposite the overlap. This procedure is necessary because if the metal paper slips out of place, it could potentially break the corrugated roof. If this occurs, you will need to begin replacing the metal shaper or building another section of metal roof to repair the damage.

This entry was posted in General. Bookmark the permalink.